Wooden Dapping Block And 7 Shaping Punches With Steel Plate

Description

This range of 7 wooden dapping punches and dapping block in a set are a fantastic addition to any workshop.

Use this forming and dapping block to create domes and angles within your metal sheet. As it is made from wood it provides a softer tool to work with, preventing surface marks and scratches.

To use for doming simply anneal metal to make it more malleable, cool, pickle and then place on doming block over the largest indent to start, (be sure to use slightly smaller punch) then strike with force using a mallet such asorto start doming/shaping. Repeat a few times, moving the punch around in a circular motion as you go. You’ll need to anneal again after a few strikes and work down the diameters until you reach your required size.

We would advise when striking to place the block onto a mat such asto defuse the vibration.

Dapping punches are sized as following; 20mm, 27mm, 30mm, 34mm, 43mm and 50mm, they are all 100mm long.

The block crevices measure; 20mm, 25mm, 30mm, 35mm, 40mm, 45mm and 55mm.

Other dapping punches and blocks are available;

• Super Nylon Doming Punches and Dapping Set:
• Artisan Doming Dapping Set of 18:
• Artisan Doming Dapping Set of 21:
• Artisan Round and Oval Combo Doming Set of 9 Square With Block:

We would advise when striking to place the block onto a mat such asto defuse the vibration.

We also recommend using wooden punches with this wooden block such as .